Cross Connection Control

Typically, water will flow from the public water supply to the consumer's plumbing distribution system. Backflow is the undesirable reversal of this flow of water and undesirable substances from the non-potable source to the potable source.
Potable Water = Drinking Water

There are two types of backflow: backpressure and backsiphonage

• Backpressure: created when the pressure within the customer's system becomes greater than the water supply pressure. Elevated tanks, heating systems and booster pumps are some of the main causes of backpressure.
• Back-siphonage: created when there is a negative or reduced pressure in the water supply main. Water main breaks or hydrant flushing are two of the main causes of back-siphonage.

A cross-connection is any actual or potential connection between the public or consumer's potable water system and any non-potable source or substance that presents a hazard to the quality of the public or consumer's potable water system. Therefore, cross-connection control is the management or "control" of these cross-connections to protect public safety by preventing backflow incidents within the public or water consumer's potable water system.

A backflow preventer is a device or assembly that is a means to prevent backflow. This device provides a physical barrier to backflow while protecting potable water supplies from contamination, it allows water to flow in one direction but never in the opposite direction.

Anti-siphon devices are essentially one-way valves designed to stop the flow of potentially contaminated water back into the drinkable (potable) water supply. Anti-siphoning capabilities are required by code on certain plumbing devices, such as exterior faucets (sill-cocks) or utility sink faucets.

YES!

See Section 2.6. Potable Water System subsection 2. Protection from Contamination

A qualified professional in your jurisdiction will utilize a backflow preventer test kit. The backflow preventer test kit is a compact portable device that measures differential pressure and is used for all testing of backflow prevention assemblies (DCVA, RP, PVB and SVB types). Depending on the model, test kits come equipped with either 3 or 5 soft seated needle valves. Equipped with a full-face scale, the kit can measure a range of 0-15 psid (psi differential). Test kits are equipped with three color-coded service hoses with inline filters for connecting the test kit to the backflow prevention assembly.

Manufacturers of backflow assemblies and most regulating authorities require annual testing to ensure the assembly is functioning properly. Backflow assemblies are mechanical devices. Just like car maintenance with regular oil changes, a backflow assembly must be checked to ensure it functions properly.

Yes! If a backflow assembly fails the test and does not meet state standards per device type, the assembly must be repaired. The water purveyor determines the time required to have the repairs made. After repair, the assembly must be re-tested to ensure proper functionality.

The water provider, local plumbing tradespersons, water consumers and all individuals performing backflow prevention assembly installation, testing and repairs have some level of responsibility for ensuring an effective, efficient cross-connection control program. The individuals performing backflow prevention assembly installation, testing and repairs are responsible for following all codes and regulations as outlined by the state and local cross-connection control program. The local plumbing tradesperson is responsible for implementing and enforcing the local plumbing codes. The water consumer is responsible for preventing unprotected cross-connections and maintaining protected cross-connections within the water consumer's facility.